Fluke DTX Series - Certifying Coaxial Cabling; Setting the Reference for Coaxial Cabling

DTX Series CableAnalyzer
Technical Reference Handbook
1-24
Setting User Preferences
The following sections describe how to change settings
you may want to adjust when you first start using the
tester.
Changing the Date, Time, and Date/Time Formats
1 Turn the rotary switch to SETUP, use D to
highlight Instrument Settings; then press
H.
2 Press
Cto go to the tab with the Date and Time
selections.
3 Use
D to highlight the setting you want to
change; then press
H.
4 To change numbers in the date or time on the Date
or Time screen, use B C to highlight the number;
then use A D to change the number.
Press
N when you are done.
5 To change the date or time format, press
J
Change Format on the Date or Time screen. Use
D to highlight the format you want; then press
H.
Changing the Length Units
1 Turn the rotary switch to SETUP, use D to
highlight Instrument Settings; then press
H.
2 Press
Cto go to the tab with the Length Units
selection.
3 Use
D to highlight Length Units; then press
H.
4 Use
D to highlight the setting you want; then
press
H.
Adjusting the Display Contrast
1 Press and hold G.
2 Use B C for coarse adjustments and K Fine
L Fine for fine adjustments.
J Default Setting sets the contrast to the default
level.
3 Press
H when you are done.
The setting is retained when you turn the tester off.
The contrast setting does not affect the battery life.