DTX Series CableAnalyzer
Technical Reference Handbook
1-14
Changing the Language
To change the tester’s language:
1 Turn the rotary switch to SETUP.
2 Use D to highlight Instrument Settings at the
bottom of the list; then press H.
3 Use
Cand D to find and highlight Language
on tab 2 at the bottom of the list; then press
H.
4 Use D to highlight the desired language; then
press H.
Powering the Tester
*
WWarning
Read the safety information at the beginning of
Chapter 2 before using the tester.
You can power the tester with the ac adapter included or
with the removable lithium ion battery pack.
If the tester does not turn on, refer to “If Something
Seems Wrong” in Chapter 9.
Charging the Battery
• To charge the battery, connect the ac adapter to the
battery pack, as shown in Figure 1-4.
• You may charge the battery when it is attached or
detached from the tester. Figure 1-4 shows how to
remove the battery.
• The battery charges fully in about 4 hours with the
tester off. A fully-charged battery lasts for at least 12
hours of typical use.
Note
The battery will not charge at temperatures
outside of 0 °C to 45 °C (32 °F to 113 °F). The
battery charges at a reduced rate between 40 °C
and 45 °C (104 °F and 113 °F).
• If the battery LED flashes red or the tester will not
turn on, see “If Something Seems Wrong” in
Chapter 9.
To Next Page
Loading...
