Getting Acquainted
Basic Features 1
1-13
Caution
All the LEDs flash if the smart remote detects
excessive voltage on the cable. Unplug the cable
immediately if this occurs.
Note
The LEDs also act as a battery gauge. See Figure
1-5 on page 1-17.
A Connector for twisted pair interface adapters.
B Pass LED lights when a test passes.
C Test LED lights during cable tests.
D Fail LED lights when a test fails.
E Talk LED lights when the smart remote is in talk
mode. Press
Oto adjust the volume.
F Tone LED lights and the tone generator turns on
when you press
P, but the main tester is not
connected.
G Low battery LED lights when the battery is low.
H P: Starts the test currently selected on the main
unit. Activates the tone generator for twisted pair
cabling if no main tester is detected. The test starts
when both testers are connected.
I O: Press to use the headset to talk to the person at
the other end of the link. Press again to adjust the
volume. Press and hold to exit talk mode.
J M: On/off key.
K USB port for updating the tester’s software with a
PC.
L Headset jack for talk mode.
M Connector for the ac adapter, as described in Figure
1-2.
N Cover for the module bay. Slide off the cover to install
optional modules, such as the fiber module.
Figure 1-3. Smart Remote Features (cont.)
To Next Page
Loading...
