DTX Series CableAnalyzer
Technical Reference Handbook
1-20
The DTX-PLA001 universal permanent link adapter has a
removable personality module. These may be changed to
customize the adapter for different jack configurations.
To change the personality module (refer to Figure 1-8):
1 Ground yourself by touching a grounded, conductive
surface.
2 Remove the link interface adapter from the tester.
3 Use your fingers to unscrew the screw on the
personality module. If necessary, you may use a flat-
blade screwdriver to loosen the screw.
4 Store the module in its original, static protection bag.
5 Put the new module in place and tighten the screw
with your fingers.
WCaution
Tighten the screw snugly with your fingers only.
Do not overtighten. Doing so can damage the
module or the end of the cable.
Static sensitive
device
Personality
module
TALK
MONITOR
ENTER
TEST
SAVE
SPECIAL
FUNCTIONS
SETUP
AUTO
TEST
SINGLE
TEST
EXIT
F1 F2 F3
amd74f.eps
Figure 1-8. Changing the Personality Module
To Next Page
Loading...
