Tutorials on Setup and Test Procedure
Certifying Fiber Cabling 2
2-13
W
i
p
e
1
2
3
4
5
6
7
8
TALK
MONITOR
ENTER
TEST
SAVE
SPECIAL
FUNCTIONS
SETUP
AUTO
TEST
SINGLE
TEST
EXIT
F1 F2 F3
TEST
LOW BATTERY
TONE
TALK
FAIL
TEST
PASS
TALK
amd46f.eps
A Tester and smart remote with fiber modules. Use
DTX-MFM modules for testing multimode fiber. Use
DTX-SFM modules for testing singlemode fiber.
B Memory card (optional)
C Two ac adapters with line cords (optional)
D Four patch cords (match fiber and connectors to be
tested, SC at tester end)
E Two short patch cords (match fiber and connectors to
be tested)
F Two adapters of the appropriate type
G Mandrels. Recommended when testing multimode
fiber. See Chapter 5.
H Fiber cleaning supplies
Note
To run an Autotest without connecting to cabling,
you may connect the tester and remote together
with two SC/SC patch cords.
Figure 2-7. Equipment for Testing in Smart Remote Mode
To Next Page
Loading...
