Freeman 280 - Page 96

96
Rev 4/2018
LUBRICATION AND MAINTENANCE
ITEM
ITEM
DESCRIPTION
POINTS DESCRIPTION
APPROVED
MATERIAL
Every 50 Hours or
15,000 bales
*Engine, see engine manufacturer's operator's manual
3 Front wheel nuts 24 Tightento163N•m(120lb-ft)
7 Caster fork pivot 2 Grease
15 Engine* fuel filter 1 Check for water and sediment.
20
Cab fresh air filter/pre
cleaner
2 Clean
27 Con rod, bullgear side 1 Grease
28 Knotter trip lever 1 Grease
29 Feed arm latch 1 Grease
30
Feed arm bearing
housing
Grease
31 Side plate bearing 2 Grease
32 Pinion shaft bearings 1 Grease
33 Feed arm yokes 6 Grease
34 Saddle lever 1 Grease
Every 100 Hours
3 Wheel drives 2 Check oil level
SAE 85W/140
API-GL5
8 Rear wheel hub 2 Check bearings, grease hub
21 Tires 3
Check pressure
Front (18.4 - 26) 3.17 Bars - 46 PSI
Rear (21.5 - 16.1) - 1.93 Bars- 28 PSI
Gearbox crank arm &
feeder arm
4 Tighten bolts to 340 ft-lbs
Every 250 Hours
Engine, see engine manufacturer's operator's manual
14 Engine* oil and filter 2 Replace oil and filter
23 Cab recirculating filter 1 Clean
Gearbox oil, baler Change oil (approx. 1.5 gallons)
Mobilube HD PLUS
85W-90 gear oil
Every 400 Hours or
Each Season
19
Hydrostatic filters
2
Replace
907619
41 1 907622
Every 500/12 Month
*Engine, see engine manufacturer's operator's manual
Engine* mounts 4 Check engine mounts
15
Engine* crank case vent
tube
1 Clean