About Internet Fax
119
Fax
4
Note • The e-mail received by the fax gateway is deleted even if the fax was not correctly sent.
• The settings configured in [Communication Mode] of the [Transmission Options] screen
apply to the communication mode used between the fax gateway and the fax machine.
• Fax forwarding can be restricted by setting [Fax Transfer from Address Book] and [Fax
Transfer Maximum Data Size] in the system setting.
1 Display the [Fax/Internet Fax]
screen and select [iFax/Fax]
several times to display iFax in the
Recipient section.
2 Select the profile for setting each
feature as necessary.
3 Enter the e-mail address for the
recipient that will receive the e-mail as shown below.
FAX= 0312345678 /T33S=123 @myhost. example.com
Example Fax number ..................................................0312345678
F code (if necessary)..................................../T33S=123
Host name of the receiving machine ............myhost
Domain name of the receiving machine .......example.com
Note • If the hard disk of the machine becomes full during scanning of a document, a screen
appears to prompt you to select whether to send the job up to the stored pages or to cancel
the job. Choose one of the processes.
• If the hard disk of the machine becomes full during iFax transmission, the transmission is
cancelled and the document data is deleted.
Forwarding Documents Stored in a Mailbox
The following describes the feature to automatically forward fax documents stored in a
mailbox, as e-mail attachment.
Fax documents sent to mailboxes using the fax signal method (proprietary
communication procedures), F Code method or DTMF method, and fax documents
stored in mailboxes by the Box Selector feature can be forwarded as e-mail
attachments.
Important • This feature can only be used when the mail receiving protocol is SMTP.
For information on the mailbox forwarding settings, sending to mailboxes, using the Box Selector to
receive documents in a mailbox, and printing or deleting documents received in a mailbox, refer to
"Printing/Deleting Documents in the Mailbox" (P.208).
îš„Forwarding iFax
The machine can automatically forward fax documents received in a mailbox or fax
documents stored in a mailbox by the Box Selector feature to the forwarding address
specified for the mailbox as e-mail.
FAX=
(fixed characters)
Fax number of
the recipient
/T33S= (fixed
characters) and F
code (for specifying
the F code)
@ + host name of
the machine that
converts and sends
the received e-mail
as a fax.
Domain
name
To Next Page
Loading...
Need help?
General
