14 Maintenance
428
Maintenance
14
2 Wipe the document glass with a
soft cloth moistened with water to
remove any dirt, and then wipe it
with a soft, dry cloth.
Important • Do not use cleaning agents
other than water or neutral
detergent.
Note • If dirt does not come off easily,
gently wipe it with a soft cloth
moistened with a small
amount of neutral detergent.
Cleaning the Film and Constant Velocity Transport Glass
If the machine is equipped with a document feeder, and its film and constant velocity
transport glass are dirty, streaks or smears may appear on copies and the machine
may not properly detect document sizes.
To ensure clean copies at all times, clean the document feeder roller about once a
month.
Important • Do not use benzene, paint thinner, or other organic solvents. Doing so might damage paint
or coating on plastic parts.
• Cleaning the machine with an excessive amount of water may cause the machine to
malfunction or damage documents during copying.
1 Wipe the film with a soft cloth
moistened with water to remove
any dirt, and then wipe it with a
soft, dry cloth.
Important • Do not press the film with an
excessive force as it can be
easily damaged.
• Do not use cleaning agents
other than water or neutral
detergent.
Note • If dirt does not come off easily, gently wipe it with a soft cloth moistened with a small amount
of neutral detergent.
2 Wipe the document feeder glass
with a soft cloth moistened with
water to remove any dirt, and then
wipe it with a soft, dry cloth.
Important • Do not use cleaning agents
other than water or neutral
detergent.
Note • If dirt does not come off easily,
gently wipe it with a soft cloth
moistened with a small
amount of neutral detergent.
To Next Page
Loading...
