Replacing Consumables
423
Maintenance
14
5 Return the unit to its original
position.
6 Close the front cover of the finisher.
Note • A message will be displayed and the machine will not operate unless the front cover is
completely closed.
Emptying the Punch Scrap Container (When C Finisher or C Finisher with
Booklet Maker is Installed)
When the C Finisher (optional) or C Finisher with Booklet Maker (optional) is installed
and the punch scrap container becomes full, a message appears on the touch screen.
Discard the scraps according to the message.
If you take the punch scrap container out of the machine, make sure to empty it
completely. If it is reinstalled with some scraps remaining, it may become full before the
message appears again, and this can cause machine breakdown.
Important • When emptying the punch scrap container, make sure that the machine is switched on. If not
switched on, the machine will not recognize that the punch scrap container has been
emptied.
1 Make sure that the machine has
stopped, and open the front cover
of the finisher.
2 Pull out the punch scrap container
R4 towards you.
3 Discard all the scraps.
To Next Page
Loading...
