14 Maintenance
420
Maintenance
14
8 Remove the tab from the new
staple cartridge as shown.
9 Insert the staple cartridge into the
machine until you hear it click into
place
.
10 Close the front cover of the finisher.
Note • A message will be displayed and the machine will not operate unless the front cover is
completely closed.
Replacing the Staple Cartridge (with C Finisher or C Finisher with Booklet
Maker)
When the C Finisher (optional) is installed and it is time to replace the staple cartridge,
a message appears on the touch screen. When this message appears, load a new
staple case into the staple cartridge.
This section explains how to remove jammed staples from the C Finisher with Booklet
Maker. Use the same procedures for the C Finisher.
Important • The use of staple cartridges not recommended by Fuji Xerox may impair quality and
performance. Use only staple cartridges recommended by Fuji Xerox.
Note • To order a new staple cartridge, contact our Customer Support Center.
1 Make sure that the machine has
stopped, and open the front cover
of the finisher.
To Next Page
Loading...
