14 Maintenance
418
Maintenance
14
12 Pull down the handle stopper to
lock the handle.
13 Close the front cover.
Note • A message will be displayed and the machine will not operate if the front cover is not
completely closed.
Replacing the Staple Cartridge (With B Finisher)
When the B Finisher (optional) is installed and it is time to replace the staple cartridge,
a message appears on the touch screen. When this message appears, load a new
staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may impair quality and
performance. Use only staple cartridges recommended by Fuji Xerox.
Note • To order a new staple cartridge, contact our Customer Support Center.
1 Make sure that the machine has
stopped, and open the front cover
of the finisher.
2 Grip the lever as shown in the
figure to pull out the staple
cartridge to the right, towards you.
3 Move up the staple cartridge to
take it out of the machine.
To Next Page
Loading...
