14 Maintenance
422
Maintenance
14
Replacing the Staple Cartridge for Booklet (When a C Finisher with
Booklet Maker is Installed)
When the C Finisher with Booklet Maker (optional) is installed and it is time to replace
the booklet staple cartridge, a message appears on the display. When this message
appears, load a new staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may impair quality and
performance. Use only staple cartridges recommended by Fuji Xerox.
Note • To order a new staple cartridge, contact our Customer Support Center.
1 Make sure that the machine has
stopped, and open the front cover
of the finisher.
2 While pressing the levers R2 and
R3 to the right, pull out the unit.
3 Hold the left and right tabs on the
booklet staple cartridge to pull the
cartridge out.
4 Hold the left and right tabs on the
booklet staple cartridge to return
the cartridge to its original position,
and gently push the cartridge until
you hear it click into place.
R2
R3
To Next Page
Loading...
