10 System Settings
292
System Settings
10
Copy Mode Settings
In [Copy Mode Settings], you can make settings relating to the copy feature. The
following shows the reference section for each item.
Copy Tab...................................................................................................................................292
Copy Defaults ...........................................................................................................................293
Copy Control.............................................................................................................................297
Original Size Defaults...............................................................................................................299
Reduce/Enlarge Presets.............................................................................................................299
Custom Colors...........................................................................................................................299
1 On the [System Settings] screen, select [System Settings].
For the method of displaying the [System Settings] screen, refer to System Settings Procedure (P.258).
2 Select [Copy Mode Settings].
3 Select the item to be set or changed.
Copy Tab
You can change the tray and an enlargement/reduction ratio appearing on the [Copy]
screen. By setting most commonly used tray and ratio, you can reduce the number of
selection operations for making a copy.
Features Allocation
You can set the features that appear in the third and fourth columns from the left of the [Copy]
screen. By setting the most commonly used features, you can avoid extra operations such as
selecting tabs.
1 Select [Features Allocation], and
select [Change Settings].
2 Select the number of features
displayed on the [Copy] screen.
3 From the buttons appearing on the
right, select the position where you want to allocate a feature.
Note • The position of the buttons on the right of the screen shows the position of the buttons in the
[Copy] screen.
5 Features
The [Output Color], [Reduce/Enlarge], [Paper Supply], [2 Sided Copying], and [Finishing]
features are displayed on the [Copy] screen. You cannot change the displayed features and
their positions.
6 Features
You can set the features appearing in the fourth column from the left of the [Copy] screen. Up
to 3 features can be allocated. [Output Color], [Reduce/Enlarge], and [Paper Supply] cannot
be allocated.
8 Features
You can set the features appearing in the third and fourth columns from the left of the [Copy]
screen. Up to 5 features can be allocated. However, [Output Color] at the top in the third
column is fixed.
Note • [Output Color], [Reduce/Enlarge], and [Paper Supply] cannot be allocated.
To Next Page
Loading...
