Copy Mode Settings
299
System Settings
10
Same as Side 1
Prints in the same position as the front side.
Page Number Position (Side 2)
When an annotation page is specified for 2 sided copying, set where to place the page
printed on the reverse side.
Opposite to Side 1
Prints in a position symmetrically opposite to the front side.
Same as Side 1
Prints in the same position as the front side.
Original Size Defaults
Set the original sizes that appear in [Original Size] in the [Layout Adjustment] screen.
Original sizes can be assigned to the buttons other than [Auto Size Detect].
When frequently making copies of non-standard size originals, by presetting the non-
standard size, you can save time to enter the original size each time a copy is made.
A/B Series Size
You can select from sizes of A and B series.
Inch Size
You can select from sizes of inch series.
Others
You can select from other sizes.
Variable Size
You can enter any size. Set the width (X) from 15 to 432 mm, and the height (Y) from 15 to
297 mm in 1 mm increments.
Reduce/Enlarge Presets
Set the magnifications shown in [Preset %], in [Reduce/Enlarge] in the [Copy] screen.
You can assign any magnification to the R/E Preset buttons.
Custom Colors
Set the custom colors used for [Single Color] and [Dual Color] in [Output Color].
You can assign custom colors with yellow (0 to 100%), magenta (0 to 100%), and cyan
(0 to 100%) to each of custom color buttons 1 to 6.
Note • Adjust so that the total of yellow, magenta, and cyan does not exceed 240%.
Annotation - Create Stamps
Register text to be printed with [Stamp] under [Annotation]. You can enter up to 32
characters.
For information about how to enter characters, refer to Entering Text (P.271).
To Next Page
Loading...
