10 System Settings
298
System Settings
10
Important • This feature is applied only when a copy is made with the document glass. This setting is not
reflected in the magnification (100%) under [Variable %], [Independent X-Y%] or [Calculator
%].
Note • A magnification displays [100%] even if [Fine-tune 100%] is set.
Background Suppress (Photo & Text)
Set the background suppression level for color copying. This setting is valid when [Photo &
Text] is selected for [Original Type] on the [Image Quality] screen.
The larger the value, the stronger the effect of removing background noise.
Background Suppression Level (Text)
Set the background suppression level for color copying. This setting is valid when [Text] is
selected for [Original Type] on the [Image Quality] screen.
The larger the value, the stronger the effect of removing background noise.
Photo & Text/Printed Original
Set the type of original when [Halftone] of [Photo & Text] is selected for [Original Type] in the
[Image Quality] screen.
îš„Normal
Copies with standard image quality.
îš„Inkjet Originals
Select when copying an original printed with an inkjet printer. This improves the recognition of
inkjet colors.
îš„Highlighted Originals
Select when copying an original marked with a highlight pen. This improves the recognition of
the highlight pen colors.
Original Type - Lightweight Originals
When [Text] is selected for [Original Type] in the [Image Quality] screen, set whether to
display a special original ([Lightweight Originals]).
Stamp Density
Set the translucency of the stamp printed as annotation.
You can select from three translucency values: Darken, Normal, and Lighten. Darken
represents no translucency.
Note • If the stamp with [0%] density is printed over text, the text may no longer be readable.
Stamp Position (Side 2)
When an annotation stamp is specified for 2 sided copying, set where to place the stamp
printed on the reverse side.
îš„Opposite to Side 1
Prints in a position symmetrically opposite to the front side.
îš„Same as Side 1
Prints in the same position as the front side.
Date Position (Side 2)
When an annotation date is specified for 2 sided copying, set where to place the date printed
on the reverse side.
îš„Opposite to Side 1
Prints in a position symmetrically opposite to the front side.
To Next Page
Loading...
Need help?
General
