Error Code
483
Problem Solving
15
016-751
O [Cause] 1. During the PDF Bridge processing, one of the following
occurred: a syntax or parameter error occurred; an
undefined command was used; and a PDF file was
damaged.
2. When [Print Processing Mode] for the PDF Direct Print
feature has been set to [PS]: Cause 1 or insufficient
memory.
[Remedy] For Cause 1: Use the print driver to print the document.
For Cause 2: Take one of the following actions:
z
Use the print driver to print the document.
z
Expand the PostScript memory.
For information on the memory, refer to "Allocate Memory" (P.303).
016-752
O [Cause] Unable to process for PDF Bridge due to insufficient
memory space.
[Remedy] Change the [Print Mode] setting from [High Image Quality]
to [Normal], or from [Normal] to [High Speed]. Or, add
memory.
016-753
O [Cause] The entered password does not agree with that of the PDF
file.
[Remedy] Set the correct password on ContentsBridge.
016-755
O [Cause] Attempted to process a print protected PDF file.
[Remedy] Cancel the print protection using Adobe Reader, and try to
print again.
016-756
O [Cause] No permissions to use the service.
[Remedy] Check with your System Administrator.
016-757
O [Cause] The password is incorrect.
[Remedy] Enter the correct password.
016-758
O O O O [Cause] No permissions to use the service.
[Remedy] Check with your Auditron Administrator.
016-759
O O O [Cause] The number of pages reached the maximum number of
pages for this service.
[Remedy] Check with your Auditron Administrator.
016-760
O [Cause] An error occurred during PostScript (optional) processing.
[Remedy] Take one of the following actions:
z
Set [Print Mode] to [Normal].
z
Expand PostScript memory.
For information about [Print Mode], refer to the print driver's online help.
For information about memory, refer to "Allocate Memory" (P.303).
016-761
O [Cause] An error occurred during image processing.
[Remedy] Set [Print Mode] to [Normal] and try again. If the problem
persists, set [Page Print Mode] to [On].
016-762
O [Cause] The specified print language is not installed on the
machine.
[Remedy] In [Specify Print Mode] under [Port Settings], specify
another print language.
016-764
O [Cause] Unable to connect to the SMTP server.
[Remedy] Contact the SMTP server administrator.
Error Code
Category
Cause and Remedy
CPFSMO
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
To Next Page
Loading...
Need help?
General
