• Floor installation
Use 4 screws (accessory) to fasten the unit to the floor.
• Wall installation
Remove the 2 screws and replace them with the hanger.
Use 4 screws (accessory) to fasten the unit to the wall.
Screw (Accessory)
Wall
Screw
Screw
¢
Connect the pipes
Connect EV kit to liquid pipe of EEV external models indoor unit.
Pipe size mm (in)
Indoor unit side
Ø6.35 (1/4) Flare connection
Outdoor unit side
Use a torque wrench to tighten the flare nut.
Holding spanner
Torque wrench
Body side
90°
Pipe size mm (in) Ø6.35 (1/4)
Tightening torque N•m 16.0 to 18.0
3-2. EV kit - (06-40) - 3. Piping connection
SYSTEM
DESIGN
SYSTEM
DESIGN
To Next Page
Loading...
