Fujitsu BS2000 User Manual

Systems on Server Units Setting BS2000 operation mode
U41855-J-Z125-3-76 111
Dokuschablonen 19x24 Version 7.4de für FrameMaker V7.x vom 09.02.2010 © cognitas GmbH 2001-2010
19. March 2018 Stand 18:25.47 Pfad: P:\FTS-BS\Server\SE-Server\SE-Doku\1303912_BuV_062\BuV_e\buv.k05
i If you change the device configuration of the monitor VM, please note the following:
– If the devices of the monitor VM are assigned or removed using the VM specific
tabs Disks, KVP, LAN, Tape devices or All devices, the changes only remain active
until the BS2000 operation mode is reset or until the SU is restarted. The same
applies for changes of the device configuration done via VM2000 commands
that refer to the monitor VM.
– If changes to the device configuration are to remain active after a change of the
BS2000 operation mode or restart of the SU, they have to be entered and
activated in the startup configuration of the monitor VM as well (see group
Startup settings: Monitor VM of the BS2000 operation mode tab).
– Changes to the startup configuration of the monitor VM have no immediate
effect on the running monitor VM.
The groups below show the current startup settings for the operation mode concerned.
Ê To change the main memory size for the Native BS2000 system, in the Startup settings:
Native BS2000 system group, click the Change icon.
Ê To change the number of virtual CPUs, the main memory settings, the device lists or the
access password for the monitor VM, in the Startup settings: Monitor VM group, click the
Change icon.
Changes will take effect only after the setting has been activated by clicking the Activate icon
in the group concerned or after you have switched the operation mode.

Fujitsu BS2000 Specifications

General

Brand	Fujitsu
Model	BS2000
Category	Server
Language	English