Managing units of the SE server Managing hardware
214 U41855-J-Z125-3-76
Adding or removing trap receivers
Ê In the Trap receiver group select one of the following procedures:
Ê To add a trap receiver, click Add new trap receiver, and after making the necessary
entries confirm the action.
Ê To remove a trap receiver, click the Remove icon in the row with the required trap
receiver and confirm the action.
Send test trap
Ê In the Trap receiver group, click the Send test trap icon in the row with the required test
receiver and confirm the action.
10.1.4.6 Setting the system time (time synchronization or local)
To ensure high time accuracy, you can also configure automatic time leveling with a so-
called NTP server, e.g. one which supplies a time which is as accurate as a radio clock,
using NTP (Network Time Protocol).
The Management Units are available as NTP servers for all units of the server via the
private management network MCNPR. SU x86 and HNC are preconfigured with respect to
NTP; AU configuration must be performed as required by the administrator responsible.
Effect on the time setting of the systems on the SE server
The time settings of the other systems are synchronized with the system time of the
Management Unit. The Management Unit is the basic timer. Refer to section “Time
synchronization” on page 65.
When changes are made to the time management which affect the Server Unit, bear in
mind that the time settings in BS2000 systems and of XenVMs that are started later are also
affected. Here you should in particular avoid large leaps in time which are caused by setting
the time manually.
Details on BS2000 are provided in the "Synchronization of the system time" section of the
"BS2000 OSD/BC System Administration" manual [10].
To Next Page
Loading...
Need help?
General