Working with the SE Manager Operating the SE Manager
94 U41855-J-Z125-3-76
3.4.4 Executing an action
This section describes how an action is typically executed.
You start an action in the SE Manager‘s working area. Two options are available after you
have selected a tab:
Ê Click a button.
Ê Click an icon in a table (e.g. Change, Delete).
Icons always belong to a particular record (of a table row) and are therefore contained
in this table row. Each icon stands for a particular task which you can execute. Detailed
information on the SE Manager's icons is provided in the SE Manager help.
After you have started the action, a dialog opens.
See the section “Main window” on page 80 for the layout.
Proceed as follows in interactive mode:
Ê If required, control the action with options.
Ê Confirm the action.
Following confirmation the action is executed and the dialog box remains open. Each action
displays feedback in the associated dialog box. You can then terminate the dialog box with
Close and thus refresh the working area of the main window. If you close the dialog box in
another way, the working area is not refreshed.
Example of how an action is executed
Ê Proceed as follows to log in on the
SE Manager:
Ê Select Hardware →
Units[ → <se server> (SE<model>)]
→ <unit> (MU) → Management,
SNMP tab.
Ê Trap receiver group: click Add new
trap receiver.
A dialog with a parameter area
opens.
To Next Page
Loading...
Need help?
General