Systems on Application Units Installing an operating system on an Application Unit
U41855-J-Z125-3-76 153
Dokuschablonen 19x24 Version 7.4de für FrameMaker V7.x vom 09.02.2010 © cognitas GmbH 2001-2010
19. March 2018 Stand 18:25.47 Pfad: P:\FTS-BS\Server\SE-Server\SE-Doku\1303912_BuV_062\BuV_e\buv.k06
– You can install the software from the ServerStart DVD1, which is supplied with the
Application Unit.
– You can install the software when the operating system is installed if you install the
operating system with the ServerView Installation Manager.
The associated installation instructions are provided in the Installation Guides for the
ServerView Operation Manager [18] and [19].
Configuring the network for the administration LAN
For the connection to the MU, AUs must be configured at the administration network.
Configure this network when you install the operating system.
Configuring LAN interfaces
The connection can either be made to the public MANPU administration network or to the
private MONPR01 administration network.
● For connection to MANPU:
Use Linux resources to configure the IP address, subnetwork and gateway.
● For connection to MONPR01:
Activate Linux for the selected eth interface DHCP for IPv6. The MU then assigns an
automatic IPv6 address in the MONPR01 network.
In case your Linux does not support IPv6, you can connect the AU to MONPR01 via a static
IPv4 address. To do so, please contact your service technician.
You configure the management network using Linux resources with the appropriate IP
addresses, subnetwork masks, and gateways.
You configure the IP address in the administration network in accordance with your
administration network, as defined with Customer Support in the installation checklist.
i There is also an option of connecting an AU to private data networks (DANPRnn)
or public data networks (DANPUnn). Ask your Customer Support staff for details.
To Next Page
Loading...
Need help?
General