Managing hardware Managing units of the SE server
U41855-J-Z125-3-76 247
Dokuschablonen 19x24 Version 7.4de für FrameMaker V7.x vom 09.02.2010 © cognitas GmbH 2001-2010
19. March 2018 Stand 18:42.31 Pfad: P:\FTS-BS\Server\SE-Server\SE-Doku\1303912_BuV_062\BuV_e\buv.k10
Change LAN configuration of the Application Unit
If your Application Unit is connected or is to be connected via MANPU, you must change or
set the IP addresses of the Application Unit for MANPU in the following cases:
● You (re)install the Application Unit.
● You change the IP address space of MANPU.
You must perform the following steps to do this:
1. Use operating system resources on the Application Unit to change or set the LAN
configuration of the LAN interface for the MANPU.
2. On the Application Unit, use the Linux and Windows operating systems to change or
set the SNMP configuration according to the (new) IP address space of the MANPU.
3. Only when you are modifying the IP address space of the MANPU:
Modify the LAN configuration of the MU using the SE Manager.
Integrating an Application Unit into status monitoring
The hardware status of the Application Unit is determined by means of an SNMP query from
the Management Unit to the ServerView agent on the Application Unit via the management
LAN. To permit this the ServerView agents must be installed and SNMP must be configured
on the Application Unit.
Detailed and operating system-specific information about the SNMP configuration is
available in the appendix of the online help (see "Further information", "Configuration on the
Application Unit").
Ê Check the implemented configuration.
The configuration is correct when the following conditions are satisfied:
– The Application Unit in the SE server overview on the Management Unit is
displayed with the status Running.
– The hardware information of the Application Unit is displayed in the information for
the Application Unit.
Integrating an Application Unit into the remote service procedure
An Application Unit is integrated into the remote service procedure with reporting of
hardware errors to the Service Center (call home) by forwarding hardware error messages
to the Management Unit. For Application Units with the Linux and Windows operating
systems, ServerView agents and the ServerView RAID Manager must also be installed for
the purpose of hardware monitoring.
To Next Page
Loading...
Need help?
General