Configuration Managing authorizations
312 U41855-J-Z125-3-76
The following options are available to you:
Allow IP address or network
Ê Click Allow IP address and enter the IP address or network in the subsequent dialog box.
Syntax: <ip address>[/<network mask>]
For a Management Cluster, you also have to determine whether the access restriction
is valid for all SE servers or only for a single SE server. The default is All.
I With the first entry (IP address or IP network) you enable IP-based access
restriction to the MUs of the SE server. Access is then only possible for IP
addresses which are entered either explicitly or via an IP network. Because of
that, the IP address of your administration PC, from which you have logged on
to the SE Manager, should be part of the first entry.
Remove IP address or network
Ê By the required IP address or network, click the Remove icon and confirm the action.
I As soon as you delete the last entry from the list for access restrictions, access
to the MUs of the SE server is once again possible for all IP addresses without
restriction. You should delete the entry that contains the address of your
administration PC last.
To Next Page
Loading...
Need help?
General