Field Description
address of the Ethernet interface is used. In the case of physical
interfaces, the current MAC address is entered by default.
If you disable Use Built-In, you enter a MAC address for the vir-
tual interface, e.g. %%%%#%' .
Some providers use hardware-independent MAC addresses to
allocate their clients IP addresses dynamically. If your provider
has assigned you an MAC address, enter this here.
DHCP Hostname Only if Address Mode = 4:+
Enter the host name requested by the provider. The maximum
length of the entry is 45 characters.
Proxy ARP Select whether your device is to respond to ARP requests from
its own LAN on behalf of defined remote terminals.
The function is activated by choosing 7#,.
The default state of the function is Disabled.
7.2 VLAN
By implementing VLAN segmentation in accordance with 802.1Q, you can configure
VLANs on your device. The wireless ports of an access point, in particular, are able to re-
move the VLAN tag of a frame sent to the clients and to tag received frames with a pre-
defined VLAN ID. This functionality makes an access point nothing less than a VLAN-
aware switch with the enhancement of grouping clients into VLAN groups. In general,
VLAN segmenting can be configured with all interfaces.
Funkwerk Enterprise Communications GmbH
7 LAN
funkwerk W1002/W2002/WIx040/WIx065 113
To Next Page
Loading...
Need help?
General
