2.3 Presettings
Preconfigured data
You have three ways of accessing your device in your network to perform configuration
tasks:
(a) Dynamic IP address
In ex works state, your device is set to DHCP client mode, which means that when it is
connected to the network, it is automatically assigned an IP address if a DHCP server
is run. You can then access your device for configuration purposes using the IP ad-
dress assigned by the DHCP server. For information on determining the dynamically
assigned IP address, please see your DHCP server documentation.
(b) Fallback IP address
If you do not run a DHCP server, you can connect your device directly to your configur-
ation PC and then reach it using the following, predefined fallback IP configuration:
• IP Address:
• Netmask:
Make sure that the PC from which the configuration is performed has a suitable IP
configuration (see Configuring a PC on page 17).
(c) Assigning a fixed IP address
You can use the ComPoint Manager to assign the required IP address to your device.
Use the following access data to configure your device as delivered:
• User Name:
• Password:
Note
All funkwerk devices are shipped with the same user name and password. As long as
the password remains unchanged, they are not protected against unauthorised use.
Make sure you change the passwords to prevent unauthorised access to your device
(see Access and Configuration on page 51).
Software update
2 Quick Install Guide Funkwerk Enterprise Communications GmbH
8 funkwerk W1002/W2002/WIx040/WIx065
To Next Page
Loading...
Need help?
General
