Chapter 2 Quick Install Guide
This chapter explains how you set up and start up your device and how you create a basic
configuration in just a few minutes.
2.1 Introduction
You can use the ComPoint Manager (IP address assignment) and the Funkwerk Config-
uration Interface (other configuration steps) for the basic configuration of your device.
The way to obtain the basic configuration is explained below step-by-step. A detailed online
help system gives you extra support.
This user’s guide assumes you have the following basic knowledge:
• Basic knowledge of network structure
• Knowledge of basic network terminology, such as server, client and IP address
• Basic knowledge of using Microsoft Windows operating systems
The CD also supplied includes all the tools that you need for the configuration and man-
agement of your device.
You can find other useful applications on the Internet at www.funkwerk-ec.com.
2.2 System requirements
For configuration, your PC must meet the following system requirements:
• Windows 95, Windows 98, Windows ME or Windows NT 4.0 or Windows 2000 or Win-
dows XP.
(The instructions for testing/installing the TCP/IP protocol and setting up the PC apply to
Windows 2000 or Windows XP.)
• Installed network card (Ethernet)
• CD ROM drive
• Microsoft TCP/IP protocol installed (see Configuring a PC on page 17)
• High colour display (more than 256 colours) for correct representation of the graphics
Funkwerk Enterprise Communications GmbH
2 Quick Install Guide
funkwerk W1002/W2002/WIx040/WIx065 7
To Next Page
Loading...
