By default, the following format instructions are entered in the Log Format field. 2-7/%
JJ"JJJ%J1J > J2%J@1JJ!JJJ8)J *
12.3 SNMP
SNMP (Simple Network Management Protocol) is a protocol from the IP protocol family for
transporting management information about network components.
Every SNMP management system contains an MIB. SNMP can be used to configure, con-
trol and administrate various network components from one system. Such an SNMP tool is
included on your device: the Configuration Manager. As SNMP is a standard protocol, you
can use any other SNMP managers, e.g. HPOpenView.
For more information on the SNMP versions, see the relevant RFCs and drafts:
• SNMP V. 1: RFC 1157
• SNMP V. 2c: RFC 1901 – 1908
• SNMP V. 3: RFC 3410 – 3418
12.3.1 SNMP Trap Options
In the event of errors, a message - known as a trap packet - is sent unrequested to monitor
the system.
In the External Reporting -> SNMP -> SNMP Trap Options menu, you can configure the
sending of traps.
Fig. 104: External Reporting -> SNMP-> SNMP Trap Options
The External Reporting -> SNMP -> SNMP Trap Options menu consists of the following
Funkwerk Enterprise Communications GmbH
12 External Reporting
funkwerk W1002/W2002/WIx040/WIx065 195
To Next Page
Loading...
Need help?
General
