Funkwerk W1002 - Interface Mode and Bridge Groups

Field Description
time protocol with UDP port 123.
• / 64 : This server uses the Time service with UDP port
37.
• / /+ : This server uses the Time service with TCP port
37.
• 4 #, : This time server is not currently used for the time
query.
Third Timeserver Enter the third time server, by using either a domain name or an
IP address.
Also select the protocol for the time server query.
Possible values:
• -/ (default value): This server uses the simple network
time protocol with UDP port 123.
• / 64: This server uses the Time service with UDP port
37.
• / /+: This server uses the Time service with TCP port
37.
• 4 #,: This time server is not currently used for the time
query.
Time Offset from GMT Select the offset in hours between the system time and the time
received from the time server (usually GMT).
Possible values are  to '.
The default value is .
Time Update Interval Enter the time interval in minutes at which the time is automatic-
ally updated.
The default value is &&.
Time Update Policy Enter the time period after which the system attempts to contact
the time server again following a failed time update.
Possible values:
• -, (default value): The system attempts to contact the
time server after 1, 2, 4, 8, and 16 minutes.
5 System Management Funkwerk Enterprise Communications GmbH
88 funkwerk W1002/W2002/WIx040/WIx065