Galvanic Applied Sciences ProTech903 - Page 10

Revision 14
10 August 02, 2019
Important Safety Guidelines for the ProTech903 H
2
S and Total
Sulfur Analyzer
Please read the following warnings and cautions carefully before using the ProTech903 H
2
S and
Total Sulfur Analyzer
This equipment must be used as specified by the manufacturer or overall safety
will be impaired.
Access to this equipment should be limited to authorized, trained personnel ONLY.
: Due to the thermal mass of the hardware, cooling of the items takes substantial
time (total sulfur furnace in the total sulfur option only).
Observe all warning labels on the analyzer enclosures.
The analog outputs and alarm relay contacts may be powered by a source separate from the
one (s) used to power the analyzer system. Disconnecting the main power source may not
remove power from the analog output signals
Any safety recommendations or comments contained herein are suggested guidelines only.
Galvanic Applied Sciences Inc. bears no responsibility and assumes no liability for the use and/or
implementation of these suggested procedures.
This system, when operating in its normal mode, and/or when it is being serviced, maintained,
installed and commissioned contains items which may be hazardous to humans if handled or
operated incorrectly or negligently. These items include, but are not limited to;
a) High Voltage Electrical Energy
b) Toxic and Explosive Gases
c) High Temperature Surfaces (total sulfur furnace in the total sulfur option only)
The ProTech903 H
2
S and Total Sulfur Analyzer can be configured to be safely operated in a
Class 1, Div.1, Group B, C and D area, or a Class 1, Div 2, Groups B, C. D area or Ex protection:
II 2G, EEx d [ia] ia em II2B T3 (T
amb
=50°) area.