Revision 14
37 August 02, 2019
Remove this packing material before inserting the quartz tube or
powering up the system.
3.4 Installation of the Software
3.4.1 Computer Requirements
Table 3-1 shows the computer requirements for the application software.
Table 3-1: Computer Requirements for Application Software
Microsoft
®
Windows 7, Windows 8, Windows 10
Disk Drives
A CD ROM drive may be required to read the installation disk
but as of April 2016,
the software, manual and QC
documentation will be placed on USB memory drives. A
minimum of 20 MB of space is required for installation on the
PC hard drive. Additional space is required to save analyzer
configurations and archive data.
USB Port
The analyzer to PC via a standard USB ‘A’ to USB ‘A’ cable
(included with the analyzer). The COM port used to connect to
the system cannot be used for any other purposes; otherwise
connecting to the system will not be possible.
Minimum required resolution is 1024 x 768.
3.4.2 Install the Application Software
The application program that is included with the analyzer allows the operator to perform
analyses and configure all aspects of the analyzer’s operation. The application program is
capable of communicating with the analyzer through USB, or Ethernet (additional hardware
and setup software required)
To install the application software:
a) Insert the compact disk or USB memory stick that was included with the system into the
CD ROM drive or USB slot respectfully of the personal computer. Use Windows Explorer
to view the contents of the CD (Figure 3-5).
To Next Page
Loading...