Galvanic Applied Sciences ProTech903 - Table 4-5: Alarms; The Alarm List; The Alarms List

Revision 14
63 August 02, 2019
• T.S. OFF - This field is used to initiate the Total Sulfur run. To initiate the Total
Sulfur run press the EDIT button, and press ENTER to toggle the status from OFF to ON.
The analyzer will run the Total Sulfur run according to the setup of the Total Sulfur run (see
Section 5.10) and then revert back to the auto-sequence.
• H2S OFF - This field is used to initiate the H
2
S run. To initiate the H
2
S run, press
the EDIT button, and press ENTER to toggle the status from OFF to ON. The analyzer will
run the H
2
S run according to the setup of the H
2
S run (see Section 5.10) and then revert
back to the auto-sequence.
4.6 The Alarms List
When F2 is selected from the main screen, a list of all alarms is presented (e.g. Off-line). The
Alarm LED will be lit when an alarm condition has been detected. The possible alarms are
listed in Table 4-5. A detailed discussion of the various alarms is presented in Section 5.6.
Table 4-5: Alarms
General System Alarms
High Temperature Alarm
Low temperature Alarm
Sensor LED Current
RTC Battery
Max Tape Advance Alarm
Low Tape Alarm
Tape Length Alarm
Tape Movement Alarm
Sensor Calibration Alarm
Bypass
DC Power Alarm
AC Power Alarm
Analog Input Alarms
AI#1 > Limit
AI#1 < Limit
AI#2 > Limit
AI#2 < Limit
AI#3 > Limit
AI#3 < Limit
AI#4 > Limit
AI#4 < Limit
Analysis Alarms - H
2
S
High Alarm
High High Alarm
Deviation
Lock
Analysis Alarms - Total Sulfur
High Alarm
High High Alarm
Deviation
Lock
Analysis Alarms - Reference 1
High Alarm
High High Alarm
Deviation
Lock
Analysis Alarms -Reference 2
)
High Alarm
High High Alarm
Deviation