Revision 14
39 August 02, 2019
a) Open the Galvanic USB Drivers folder on the computer and the QS Driver download
subfolder then double click on the QS Driver Installer to install the drivers. Follow the on
screen instructions.
If you are not using the USB mode of communication between the analyzer
and the computer, skip step b and continue to Section 3.5.4.
b) Connect the USB to USB cable that is provided with the system to the analyzer and the
personal computer. The Message Found New Hardware should be presented and the
driver installation will be completed automatically.
If this message is not presented, then reboot the computer. The analyzer
will then be recognized.
To Next Page
Loading...
