Chapter 3
Programming
95
Status beeps
Default setting is On.
This setting determines whether or not the selected touchpad sounds status beeps. Each touchpad can be set
individually. This feature is usually turned off for a touchpad that is located in or near bedrooms, to avoid
disturbing sleeping persons.
Note: For UL listed installations, Status beeps must be on.
To turn touchpad status beeps on or off, do the following:
1. With the display showing the desired touchpad, press # then A or B until the display shows KEYPAD
OPTIONS.
2. Press # and the display shows STATUS BEEPS OFF/ON (current setting).
3. Press 1 (off) or 2 (on) to select the desired setting. The display flashes the entered selection. Press #
and the display shows the new setting.
Key beeps
Default setting is On.
This setting determines whether or not selected touchpads beep when their buttons are pressed. This feature is
usually turned off for a touchpad that is located in or near bedrooms, to avoid disturbing sleeping persons.
To turn key beeps on or off, do the following:
1. With the display showing the desired touchpad, press # then A or B until the display shows KEYPAD
OPTIONS. Next, press # then A or B until the display shows KEY BEEPS OFF/ON (current
setting).
2. Press 1 (off) or 2 (on) to select the desired setting. The display flashes the entered selection. Press #
and the display shows the new setting.
Freeze temps
Default setting is 42°F.
This setting determines the temperature point that the energy saver module detects a potential freeze (heating
failure) condition. The adjustable range is from 40 to 90°F.
Note: This is the same menu found under Reporting - partition 1 to 6 settings on page 78 The setting is used by both the
SuperBus 2000 energy saver module and dialog RF thermostat. Individual freeze temperature settings for each device
are not allowed.
To change the freeze temp setting, do the following:
1. With the display showing the desired bus device press #, then A or B until the display shows ENERGY
OPTIONS. Next, press # then A or B until the display shows FREEZE TEMP nn DEGREES (current
setting).
2. Enter the desired freeze temperature (40 to 90°F). The display flashes the entered selection. Press #
and the display shows the new setting.
To Next Page
Loading...
Need help?
General
