Concord 4
Installation Manual
50
To disable keyfob PTN, do the following:
1. Enter this menu (display showing KEYCHAIN TP PTN), then press #. The display shows the lowest
touchpad sensor number assignment such as: S1 P1 G0 TP RF where S1 is sensor 1, P1 is partition
1, G0 is sensor group 0, TP is touchpad and RF is wireless.
2. Press # to accept this keyfob or press A or B until the desired keyfob appears, then press #. The display
shows ARM PARTITION.
3. Enter the partition numbers that are displayed (except for the partition you assigned the touchpad when
it was learned). Each disappears from the display with the touchpad’s original partition number left
flashing.
4. Press # and the display stops flashing.
Security partition 1 to 6 settings
The following sections describe the Security settings that appear under Partition 1 to 6.
Account number (0010 to 0060)
Default setting is 00000.
The account number is used as panel (or customer) identification for the central monitoring station. The panel
sends the account number every time it reports to the central station. Account numbers must be 1 to 10
characters long.
Alpha characters A to F can be assigned to the account number by pressing and holding buttons 1 to 6
respectively, until the character appears.
Note: When using the CID reporting format, the letter A is reported as a 0.
To program an account number, do the following:
1. With the display showing ACCOUNT NUMBER nnnnn (current number), enter the account number.
The display flashes the entered number.
2. Press # and the display shows the new number.
Quick arm (0011 to 0061)
Default setting is Off.
This feature allows system arming without using an access code. When Quick arm is on, the system arming
level can be increased from Off to Stay, from Off to Away, or from Stay to Away, without entering an access
code. A valid access code is still required to decrease the arming level or disarm the system.
To turn the setting off or on, do the following:
1. With the display showing QUICK ARM OFF/ON (current setting), press 1 (off) or 2 (on).
2. The display flashes the entered setting. Press # and the display shows the new setting.
To Next Page
Loading...
Need help?
General
