Concord 4
Installation Manual
96
Temperatures
Default setting is None.
This setting lets you adjust the energy saver module (ESM) room temperature setting to match the premises
thermostat. The adjustable range is from 40 to 90°F.
Note: To ensure accuracy, wait at least 15 minutes before setting the ESM temperature to allow the ESM to warm or cool to
actual room temperature.
To change the ESM temperature setting, do the following:
1. With the display showing the desired bus device press #, then A or B until the display shows ENERGY
OPTIONS. Next, press # and then A or B until the display shows TEMPERATURE nn DEGREES
(current setting).
2. Enter the desired temperature (40 to 90°F). The display flashes the entered selection. Press # and the
display shows the new setting.
Cellular system
Default setting is B.
This setting determines the cellular transmission system (A or B) used for cellular communication. This
information is provided by the cellular provider based on installation zip code.
To set the cellular system, do the following:
1. With the display showing the desired bus device press 1, (B) or 2 (A). The display flashes the entered
selection.
2. Press # and the display shows the new setting.
Accessory modules - SnapCard settings
The following describes how to program the Accessory module menu settings that appear under SnapCards.
Output programming
This setting lets you assign a partition and a five-digit configuration number for each SnapCard relay output.
This number determines both which system event activates the output and the duration or time the output is
activated. To program the settings, do the following:
1. Assign the partition (1 to 6).
2. Assign the configuration number (combination of a trigger number and a response number).
Trigger. The event that activates the output point. Trigger events can be partition alarms, trouble
conditions, open sensors, etc. (see Appendix B, Settings).
Response. How the output responds when trigger event occurs (see Appendix B, Settings).
To assign configuration numbers to SnapCard relay outputs, do the following:
1. With the display showing SNAPCARDS, press #. Then press A or B until the display shows OUTPUT
PROGRAMMING.
To Next Page
Loading...
Need help?
General
