Concord 4
Installation Manual
44
Partition 1 copy
Default setting is None.
After programming all settings pertaining to partition 1, you may make an exact copy to use for partitions 2 to
6. This helps reduce programming time when the system is set up for multiple partitions. If there are certain
settings that are unique to partitions 2 to 6, simply advance to the appropriate menu and make the necessary
changes.
To copy partition 1, do the following:
1. With the display showing PARTITION 1 COPY, press # + installer code + #.
2. The display flashes, press # and the display shows DONE.
Clear memory
Clearing memory deletes all existing programming information (except the dealer code).
Note: Clearing the memory erases onboard hardwired zone factory programming.
To clear panel memory, do the following:
1. With the system in program mode, press A or B until the display shows CLEAR MEMORY.
2. Press # and the display shows ENTER CODE TO CLEAR MEMORY.
3. Enter the four-digit installer or dealer code
(if programmed) + #. After about five seconds, the system
restarts and the panel scans the bus to learn all bus devices.
If the system doesn’t respond as shown, repeat the process.
To Next Page
Loading...
