Concord 4
Installation Manual
104
User programming mode
Use user programming mode to view system version information and program the following system settings:
• Time and date menu on page 104.
• User codes menu on page 105.
• Options menu on page 108.
• Set up schedules menu on page 110.
• Attach schedules to events menu on page 111.
• Energy saver menu on page 114.
• Attach lights to sensors menu on page 115.
• System version menu on page 115.
You can enter user programming from an alphanumeric or fixed display touchpad by using the system or
partition master code. The default system master code is 1234.
To enter user programming mode, press 9 + CODE. The display shows TIME AND DATE.
Time and date menu
The panel uses a global clock and calendar for time and date. Alphanumeric touchpads display the panel time
and date whenever the system is disarmed.
Note: Setting the time and date is important for accurate tracking of system events stored in the event buffer.
The Time and date menu lets you set this clock and calendar.
Time (020)
Default setting is 00:00.
This setting lets you adjust the panel clock to the correct time. The panel uses a 24-hour clock. For example, to
set the time to 4:17 p.m., enter 1617. To set the time, do the following:
1. With the display showing TIME AND DATE press # and the display shows TIME hh:mm (current
time).
2. Enter the correct time (0000 to 2359). The display flashes the entered time. Press # and the display
shows the new time.
Date (021)
Default setting is 01/01/00.
This setting lets you adjust the panel calendar to the correct month, day, and year. To set the date, do the
following:
1. With the display showing TIME AND DATE, press #, then A or B until the display shows DATE
nn/nn/nn (current date).
2. Enter the correct month (01 to 12), day (01 to 31), and year (00 to 99). For example, enter 090107 for
September 1, 2007. The display flashes the entered date. Press # and the display shows the new date.
To Next Page
Loading...
Need help?
General
