Chapter 3
Programming
105
User codes menu
The User codes menu lets you program/change regular user access codes, partition master codes, and the
system master code. You can enter up to 230 separate user codes, allowing up to 230 different users access to
the security system. You can also specify whether or not a specific user is able to perform specific actions, like
bypassing sensors or testing the system.
User nnn (030nnn0 where nnn is user number 000 to 229)
Default setting is None.
User codes provide basic arming and disarming functions. The system allows up to 230 user codes (user
numbers 000 to 229). User numbers that show **** indicate no code is currently programmed for that user
number.
To program regular user codes, do the following:
1. With the display showing USER CODES, press # and the display shows REGULAR USER CODES.
2. Press # and the display shows USER nnn (first available user number).
3. Press A or B to select the desired user number, then press #. The display shows USER nnn - nnnn.
4. With the user number displayed, enter a four-digit user code. The display flashes the entered code.
Press # and the display shows USER nnn - nnnn (new code).
To delete regular user codes, do the following:
1. With the display showing USER CODES, press # and the display shows REGULAR USER CODES.
2. Press # and the display shows USER nnn - nnnn (first available user number).
3. Press A or B to select the user number/user code you want to delete (if it is not already displayed), then
press #. The display shows USER nnn - nnnn.
4. Enter the system or partition master code. The display flashes the entered code. Press # and the display
shows USER nnn -- **** (no code).
Direct bypassing (030nnn1 where nnn is user number 00 to 229)
Default setting is Off.
This setting determines whether a specific user code provides access to the Bypass sensors feature. Set this
feature to on for all users who need to be able to bypass sensors.
To turn the setting off or on, do the following:
1. With the display showing USER CODES, press # and the display shows REGULAR USER CODES.
2. Press # and the display shows USER nnn (first available user number).
3. Press A or B to select the desired user number, then press #. The display shows USER nnn - nnnn.
4. Press A or B until the display shows DIRECT BYPASSING OFF/ON (current setting).
5. Press 1 (off) or 2 (on). The display flashes the entered setting. Press # and the display shows the new
setting.
To Next Page
Loading...
Need help?
General
