Concord 4
Installation Manual
106
Remote access (030nnn2 where nnn is user number 000 to 229)
Default setting is Off.
This setting determines whether the user can access the panel from a remote phone (a phone located off the
premises).
To turn the setting off or on, do the following:
1. With the display showing USER CODES, press # and the display shows REGULAR USER CODES.
2. Press # and the display shows USER nn (first available user number).
3. Press A or B to select the user number, then press #. The display shows USER nnn - nnnn.
4. Press B until the display shows REMOTE ACCESS ON/OFF (current setting).
5. Press 1 (off) or 2 (on). The display flashes the entered setting. Press # and the display shows the new
setting.
System tests (030nnn3 where nnn is user number 000 to 229)
Default setting is Off.
This setting determines whether a specific user code provides access to the phone and sensor tests. Set this
feature to on for all users who need to be able to conduct phone and sensor tests.
To turn the setting off or on, do the following:
1. With the display showing USER CODES, press # and the display shows REGULAR USER CODES.
2. Press # and the display shows USER nn (first available user number).
3. Press A or B to select the user number, then press #. The display shows USER nnn - nnnn.
4. Press A or B until the display shows SYSTEM TESTS OFF/ON (current setting).
5. Press 1 (off) or 2 (on). The display flashes the entered setting. Press # and the display shows the new
setting.
Latchkey report (030nnn4 where nnn is user number 000 to 229)
Defaults setting is On for 000 to 005, and Off for 006 to 229.
This setting determines whether the user code causes a latchkey report to be sent to a pager when the code is
used to change arming levels.
To assign the latchkey report attribute to user codes, do the following:
1. With the display showing USER CODES, press # and the display shows REGULAR USER CODES.
2. Press # and the display shows USER nn (first available user number).
3. Press A or B to select the user number, then press #. The display shows USER nnn - nnnn.
4. Press A or B until the display shows LATCHKEY OFF/ON (current setting).
5. Press 1 (off) or 2 (on). The display flashes the entered setting. Press # and the display shows the new
setting.
To Next Page
Loading...
Need help?
General
