Concord 4
Installation Manual
58
Streamlining (01036, 01046, 01056, 01066, and 01076)
Default setting is On.
This setting determines whether the panel includes (off) or excludes (on) the account number when reporting to
a pager. To turn streamlining off or on, do the following:
1. With the display showing STREAMLINING OFF/ON (current setting), press 1 (off) or 2 (on).
2. The display flashes the entered setting. Press # and the display shows the new setting.
Partition assignment (01037, 01047, 01057, 01067, and 01077)
Default setting is 1.
This setting determines the partition that reports to a pager. All partitions may be set to report to a single pager.
To set up partition assignments for pager reporting, do the following:
1. With the display showing PARTITION ASSIGN 1-6 (current setting), press 1 to 6 to select the
desired partitions.
2. The display flashes the entered settings. Press # and the display stops flashing.
Phones - downloader phone settings
The following describes how to program the Phones menu settings that appear under Downloader phone.
Phone number (01090)
Default setting is None.
Use this setting to enter the phone number of an offsite computer that can be used to program the panel through
the phone line. Phone numbers can be 1 to 24 digits long, including pauses or * and # characters.
• To enter pauses, press C.
•To enter *, press and hold 7 for about two seconds.
•To enter #, press and hold 9 for about two seconds.
Note: Call-waiting services should be disabled to prevent interrupting panel communication to the downloader. To program a
dialing prefix that disables call-waiting, see the Call wait cancel setting under the Phone options - global settings on
page 59.
To program a downloader phone number, do the following:
1. With the display showing PHONE NUMBER (current number), enter the phone number.
2. The display flashes the entered number. Press # and the display shows the new setting.
To delete a downloader phone number, do the following:
1. With the display showing PHONE NUMBER (current number), press D to erase the number.
2. The display shows PHONE NUMBER_.
To Next Page
Loading...
Need help?
General
