GE Security Concord 4 Installation Manual

Chapter 3
Programming
103
Quick programming mode
Use the quick programming mode to program basic system programming with a SuperBus 2000 fixed display
touchpad, SuperBus 2000 FTP 1000 touchpad, or any SuperBus 2000 alphanumeric touchpad. The following
menus are accessible:
• Account number (all partitions)
• CS phone 1
• CS phone 2
• CS phone 3
• Learn sensors—limited to selecting sensor number, sensor group, and partition assignment. An
alphanumeric touchpad is required for programming sensor text in standard programming mode.
Use A and B buttons to toggle across main menus and use the # and * buttons to toggle up and down through
submenus.
To enter quick programming mode, do the following:
1. Make sure the system is disarmed in all partitions.
2. Press 8 + installer/dealer code + 03. The display shows
ACCOUNT NUMBER.
3. Cycle through the menus as shown in Table 12.
Table 12. Quick programming
Account
number
B
A
CS phone
B
A
Learn
sensors
B
A
End
program-
ming
#
# · # · # · # · # ·
Partition n
1 -6
CS phone
1
B

A
CS phone 2 B

A
CS phone 3 Sensor
partition n
1 -6
# · # · # · # · # ·
Acct.
number
00000
CS phone
none
CS phone
none
CS phone
none
Sensor group
0
# ·
Trip sensor n
1-96

GE Security Concord 4 Specifications

General

Brand	GE Security
Model	Concord 4
Category	Security System
Language	English