Concord 4
Installation Manual
42
Menu navigation
There are two basic tiers of programming menus (Table 9).
Arrows pointing right or down represent pressing B or # to advance forward through the menus. Arrows
pointing left or up represent pressing A or * to move through the menus in reverse. Only when
SYSTEM
PROGRAMMING
is displayed can you advance to tier 2 menus.
Only when a specific menu is displayed can you advance to those menu settings. For example, from the
SENSORS menu pressing # gives you access to learning sensors, programming sensor text, deleting sensors, and
viewing/editing sensor programming. Settings in tier 2 menus can also be accessed by entering shortcut
numbers. See the section, Tier 2 programming menus on page 45 for complete details.
Exiting programming mode
After all installer/dealer programming is completed, to exit programming mode, do the following:
1. Press * until the display shows SYSTEM PROGRAMMING.
2. Press A or B until the display shows EXIT PROGRAMMING READY.
3. Press # and the touchpad displays the TIME AND DATE.
Table 9. Tier 1 and 2 menus
System
program-
ming
#
·
Security
B
A
Phones
B
A
Phone
options
B
A
Timers
B
A
B A # · # · # · # ·
B
A
Light
controls
B
A
Touchpad
options
B
A Reporting
B
A
Siren
options
B
A
# · # · # · # ·
B
A Sensors
B
A
Audio
verification
B
A
Accessory
modules
B
A
Onboard
options
B
A
# · # · # · # ·
B
A Macro keys
To Next Page
Loading...
Need help?
General
