Chapter 3
Programming
49
Keyfob PTN (0006)
Default setting is On.
This feature controls which partitions the selected keyfob can arm/disarm. When enabled, the selected keyfob
can arm/disarm the partitions selected in this menu. When disabled, the selected keyfob cannot arm/disarm
multiple partitions. For this feature:
• If no keyfobs are learned into panel memory, the menu displays NOT AVAILABLE. When keyfobs
are learned into panel memory, two submenus appear. The first one lets you view keyfob assignments
similar to that of viewing learned sensors. The second submenu lets you view and change the
multipartition arming assignments for that keyfob.
• At least two partitions must be selected.
• Keyfobs can arm/disarm multiple partitions only for those partitions set up in the Multipartition arm/
disarm menu.
• A partition cannot be armed/disarmed if it is being controlled by another source at that time.
• When arming multiple partitions from a keyfob, any conditions that prevent arming are identified on
touchpad displays in the partition where that condition exists. Touchpad displays in all other partitions
being armed display PROTEST. The normal protest/auto force arm sequence follows, or pressing * on
any touchpad in a partition being armed cancels the arming request. Pressing the Lock button again
during a protest bypasses any open sensors in the affected partitions and arms those partitions.
• When disarming multiple partitions with a keyfob and alarms are active in one or more of the assigned
partitions.
• Protest beeps sound for five minutes in all partitions being disarmed;
• Partitions in alarm where sirens have timed out sound protest beeps for five minutes;
• Partitions in alarm with active sirens continue sounding the alarm
• In any case where alarms are active the premises may not be safe to enter. The user has these options:
• Leave and call for help from a safe location;
• If entering the premises anyway, go to a hardwired touchpad and check the system status to
determine the alarm. Disarm and alarm memory is displayed for all assigned partitions;
• Press the keyfob Unlock button a second time (within the five minute protest period) to disarm all
assigned partitions and cancel all alarms, then go to a hardwired touchpad and check alarm
memory.
To enable keyfob PTN, do the following:
1. Learn all keyfobs into panel memory. (See Sensors menu on page 85.)
2. Enter this menu (display showing KEYFOB TP PTN), then press #. The display shows the lowest
touchpad sensor number assignment such as: S1 P1 G0 TP RF where S1 is sensor 1, P1 is partition
1, G0 is sensor group 0, TP is touchpad and RF is wireless.
3. Press # to accept this keyfob or press A or B until the desired keyfob appears, then press #. The display
shows ARM PARTITION.
4. Enter the desired partitions 1 to 6 (at least two). The display flashes the entered partitions.
5. Press # and the display stops flashing.
To Next Page
Loading...
Need help?
General
