EasyManuals Logo

GE Security Concord 4 Installation Manual

GE Security Concord 4
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
Concord 4
Installation Manual
48
Multipartition arm/disarm (0004)
Default setting is Off. Partition to turn On.
This feature controls which partitions can be armed/disarmed simultaneously when using a touchpad and
access code assigned to those partitions. When enabled, users can arm/disarm selected partitions using an
authorized access code. When disabled, multiple partitions cannot be armed/disarmed simultaneously. For this
feature:
At least two partitions must be selected.
Touchpads must be assigned to at least one of the selected partitions of this menu.
Access codes must be assigned to all selected partitions of this menu. If the partition assignment for a
specific access code does not match the partitions selected in this menu, only those partitions common
to both menu settings can be armed/disarmed simultaneously with that code.
A partition cannot be armed/disarmed if it is being controlled by another source at that time.
All arming modifiers except Silent affect all partitions being armed. Only the arming partition can be
armed silently.
When arming multiple partitions, any conditions that prevent arming are identified on touchpad
displays with the affected partition number flashing. The normal protest/auto force arm sequence
follows, or pressing * cancels the arming request.
When disarming multiple partitions, any partitions in alarm have the affected partition number flashing
on touchpad displays. Pressing # cancels all alarms in the selected partitions. Alarm memory
information is then displayed for all canceled alarms.
To enable multipartition arm/disarm, do the following:
1. With the display showing MULTI-PIN ARM/DISARM_, press 1 to 6 to enter partitions (at least two).
2. The display flashes the partitions. Press # and the display stops flashing.
To disable mulitipartition arm/disarm, do the following:
1. With the display showing MULTI-PTN ARM/DISARM n n n n n n n, select all of the partitions
by entering the appropriate partition number.
2. The partition numbers disappear from the display. Press #.

Table of Contents

Other manuals for GE Security Concord 4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE Security Concord 4 and is the answer not in the manual?

GE Security Concord 4 Specifications

General IconGeneral
BrandGE Security
ModelConcord 4
CategorySecurity System
LanguageEnglish

Related product manuals