Chapter 3
Programming
47
Dealer code (0002)
Default setting is None.
The four-digit dealer code is used to prevent unauthorized persons from changing the programmed central
station phone numbers and downloader code. When this feature is enabled, central station phone numbers and
downloader code cannot be changed (unless you enter the program mode by using the dealer code). All other
system settings are still accessible by entering the program mode with the installer code.
Note: The dealer code cannot be deleted by clearing panel memory.
To program a dealer code, do the following:
1. With the display showing DEALER CODE ****, enter the four-digit code.
2. The display flashes the entered code. Press # and the display shows the new code.
To delete a dealer code, do the following:
1. With the display showing DEALER CODE nnnn (current code), press D.
2. The display shows DEALER CODE ****.
Access code lock (0003)
Default setting is On.
This feature determines whether or not the panel includes access codes when sending user information to the
automation module. When this option is on, it means the access codes are not sent.
To turn the setting off or on, do the following:
1. With the display showing ACCESS CODE LOCK ON/OFF, press 1 (off) or 2 (on).
2. The display flashes the entered setting. Press # and the display shows the new setting.
Partition security (0004)
Default setting is On.
This feature controls whether an access code is necessary for partition jumping. When on, you must jump
partitions with an access code by pressing 8 + CODE + 6 + PTN. When off, you may jump partitions without
an access code by pressing 7 + 4 + PTN n (n = 1 to 6).
Note: Regardless of the setting, you may always use an access code to jump partitions.
To turn the setting off or on, do the following:
1. With the display showing PIN SECURITY (current setting), press 1 (off) or 2 (on).
2. The display flashes the entered setting. Press # and the display shows the new setting.
To Next Page
Loading...
Need help?
General
