GE Security Concord 4 Installation Manual

Concord 4
Installation Manual
138
* These devices not listed, investigated, or verified by UL.
** UL listing applied for.
† Listed, but not tested for compatibility by UL.
†† Total current only for all 2-wire smoke detectors connected to panel 2-wire smoke loop.
Note: When installing SuperBus 2000 RF receiver modules, the antenna tamper feature must be set to off. (see Reporting -
global settings on page 73).
60-836 Voice only module (with current jumper installed) (with
current jumper removed)
600mA
60-777-01 Phone interface/voice module 600 mA
600-1025-01-95R RF transceiver 55 mA
60-764-01-95R RF receiver 35 mA
600-1019 2-amp power supply N/A
60-756 4 input/2 output SnapCard 185 mA
60-757 8Z hardwired zone expander SnapCard 230 mA
60-758 4 output SnapCard 130 mA
60-774 Hardwired input module 35 mA
60-770 Hardwired output module 180 mA
60-620-01* Energy saver module 20 mA
60-850
60-850-01
Cellular backup module (standard power)
Cellular backup module (high power)
1600 mA
60-861 Wireless gateway-ready kit 1900 mA
60-677* Interrogator 200 audio verification module 1600 mA
60-783-02* Automation module 10 mA
60-528 Hardwired interior speaker 35 mA
13-060 15-watt speaker 500 mA
Total power consumption:
Total power consumption not to exceed:
mA
1,000 mA
Table 21. Hardware devices
Part no. Description Qty. mA (max.) Subtotal

GE Security Concord 4 Specifications

General

Brand	GE Security
Model	Concord 4
Category	Security System
Language	English