GE Security Concord 4 Installation Manual

Concord 4
Installation Manual
64
Phone panic (0216 to 0266)
Default setting is Off.
This setting determines whether or not a police panic alarm can be activated from a touch tone phone. When
this feature is on, pressing # + ****** from a touch tone phone on the premises causes a panic alarm.
To turn the setting off or on, do the following:
1. With the desired partition selected, press A or B until the display shows PHONE PANIC OFF/ON
(current setting). Press 1 (off) or 2 (on).
2. The display flashes the entered setting. Press # and the display shows the new setting.
Phone access key (0216 to 0265)
Default setting is #.
This setting determines which touch tone phone button is used for system access and control. If the local phone
control feature is enabled, the user can pick up the phone and press # (within 5 seconds) to access the security
system. The panel seizes the phone line and waits for the user to enter system commands. Phone access can be
changed from # to *.
Note: Use the default setting (#) to avoid conflicts between the security system and other phone devices and services. Many
phone devices and services require * to initiate their operation, so using * for this security feature could cause conflicts.
To change the Phone access key, do the following:
1. With the desired partition selected, press A or B until the display shows PHONE ACCESS KEY #/*
(current setting). Press 1 (*) or 2 (#).
2. The display flashes the entered setting. Press # and the display shows the new setting.

GE Security Concord 4 Specifications

General

Brand	GE Security
Model	Concord 4
Category	Security System
Language	English