Access control applications
EST3 Installation and Service Manual 3.29
Hardware configuration
The maglock peripherals consist of the following:
• Passive infrared motion detector (PIR)
• Request to exit (REX) switch
The PIR is connected via the CRC input circuit. The REX is
connected directly to the maglock instead of the CRC input
circuit to meet NFPA requirements.
SDU programming
When programming the system for this application you’ll need
to configure the CRC, defining the device type. You’ll also need
to define the input circuits. For this application define the input
circuit for the PIR as follows:
• Device type = Security interior
• Application = Request to exit motion detector.
To Next Page
Loading...