Power-up and testing
EST3 Installation and Service Manual 6.23
Notification appliance testing
The procedures listed in the following sections should be
performed on the notification appliances connected to the
system, in conjunction with the procedures in “Detector, input
module, and output module initial and reacceptance testing.”
These procedures are designed to test the notification appliances
and the network applications programming.
Visual devices
1. Visual Inspection
2. Activate the circuit. Verify all indicating appliances
operating properly.
3. Open up the circuit. Verify that the appropriate circuit
Trouble and location message is displayed on the LCD
module.
Speakers
1. Visual Inspection
2. Activate the circuit. Verify all indicating appliances
operating properly.
3. Open up the circuit. Verify that the appropriate circuit
Trouble and location message is displayed on the LCD
module.
Bells and horns
1. Visual Inspection
2. Activate the circuit. Verify all indicating appliances
operating properly.
3. Open up the circuit. Verify that the appropriate circuit
Trouble and location message is displayed on the LCD
module.
To Next Page
Loading...