GE Security EST3 - Page 31

System overview
EST3 Installation and Service Manual 1.15
80
78
77
81
82
83
80th floor, west wing evacuation message:
A fire has been reported on the west wing
of the 80th floor.
30th floor, north wing evacuation message:
A fire has been reported on the north wing
of the 30th floor.
Generic (default) message:
An emergency has been reported in the
building. Remain where you are and await
further instructions.
Location specific messages
Generic (default) evacuation message
The generic (default) evacuation
message plays when multiple location-
specific messages have been requested
by the system, or when no location-
specific message has been specified.
79
30
28
27
31
32
33
29
Figure 1-9: Automatic Message Processing
Firefighter phone
The 3-FTCU contains a master telephone handset that provides
an analog telephone riser for totally independent 2-way
communications between the fire command station and
Firefighter telephone stations / jack telephones installed at
strategic locations throughout the protected facility.
Taking a telephone off-hook or plugging into a telephone jack
generates a visual and audible incoming call signal at the fire
command station. The individual originating the call hears a tone
until the handset is connected to the system. The fire command
station operator manually connects the incoming phone call to
the phone riser to complete the call. Up to five remote telephones
may be connected to the riser simultaneously. The fire command
center operator can also use the telephone circuit as a page
source, permitting paging via the telephone system.